Kohler K-1913-R-96 Installation Guide download pdf (Page 20)

11. Install the Drip Tray

All Installations

Install the drain to the drip tray following the drain manufacturer’s instructions.

When Reassembling the Bath:

NOTE: These steps are not required if the drip tray was not removed in a previous step. If the drip tray is

already assembled, go to ″All Installations″ below.

Install the drain to the drip tray following the drain manufacturer’s instructions.

Carefully move the drip tray into position, rotating it up and in.

Reconnect the drip tray to the frame using the existing holes and screws that were removed

previously.

IMPORTANT! Make sure the drip tray and pulley assemblies do not contact each other. If the drip tray

and pulley assembly come in contact with each other, remove the drip tray, remove any obstructions with

subﬂoor, and reposition the drip tray as needed.

IMPORTANT! Cover the drip tray with protective material to avoid damaging it.

All Installations

Connect the drain to the drain outlet.

Route the accumulator drain line loosely through the cable tie attached to the drip tray. Locate the

outlet of the drain line directly over the drain, with a minimum 2-1/2″ (6.4 cm) air gap.

IMPORTANT! Cover the drip tray with protective material to avoid damaging it.

Board

Install, route and secure

accumulator drain line

to drip tray.

Drip Tray

Cable

Tie

Clamp

Install drain and attach to drip tray.

Strainer Body

Accumulator

Drain Line

Pulley

Assembly

Approximately

1/4" (6 mm)

clearance required

from drip tray.

2-1/2" (6.4 cm) Minimum Air Gap

1128532-2-C 20 Kohler Co.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 135 136

No comments

Kohler K-1913-R-96 Installation Guide Page 20