Kohler K-2732-F25 Installation Guide download pdf (Page 4)

1. Prepare the Site

NOTICE: To properly secure the vanity, the top of the required 2x6 backing material

must be 32-3/4″ (832 mm) from the ﬁnished ﬂoor.

Measure and mark 32-3/4″ (832 mm) up from the ﬂoor. This will be the height

from the ﬂoor to the top of the 2x6 backing material.

Ensure there are no obstructions in the wall (such as wiring or plumbing) from

the marked height down to the ﬂoor. If there are obstructions, select another area

within the site to install the vanity.

NOTE: Extend the backing material beyond the width of the vanity to the nearest

stud. This will ensure proper support for the vanity.

Front-notch the studs 1-1/2″ (38 mm) to ensure the 2x6 backing material is ﬂush

against the studs.

Secure the 2x6 backing material to the studs with framing nails.

Rough-in the water supply and drain lines into the rough-in plumbing area of the

vanity.

NOTICE: To avoid the risk of product damage, the ﬁnished wall must be straight and

plumb. If the ﬁnished wall is not straight and plumb, the vanity will not be properly

supported.

Complete the ﬁnished wall. Make sure the ﬁnished wall is straight and plumb,

and the ﬂoor is ﬂat and perpendicular to the ﬁnished wall.

Préparer le site

NOTICE: Pour bien ﬁxer le meuble, le dessus du matériau de renfort 2x6 requis doit

se trouver à 32-3/4″ (832 mm) du plancher ﬁni.

Mesurer et marquer 32-3/4″ (832 mm) vers le haut à partir du sol. Ceci sera la

hauteur entre le plancher et le dessus du matériau de renfort 2x6.

S’assurer qu’il n’y ait pas d’obstructions dans le mur (telles que câblage ou

plomberie) à partir de la hauteur marquée vers le sol. Si ilyadesobstructions,

sélectionner une autre zone sur le site pour installer le meuble.

32-3/4" (832 mm)

2x6 Backing Material

Matériau de renfort 2x6

Material de refuerzo de 2x6

1146261-2-C 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Kohler K-2732-F25 Installation Guide Page 4