Kohler K-705704-L-NX Installation Guide download pdf (Page 16)

11. Adjust and Secure the Door

CAUTION: Risk of injury or product damage. Unframed tempered glass should not contact hard

surfaces or it may shatter. Do not touch the edge of the tempered glass panel with tools or any hard

objects. Do not set the unframed tempered glass directly on the ﬂoor.

CAUTION: Do not allow the edges of the glass panel to contact the bottom track, or the seals. Contact

may shatter the glass or tear the seals.

Install the handles following the instructions packed with them.

Align the door with the strike lite glass panel.

IMPORTANT! Only loosen the screws enough for the door panel to move. If the screws are loosened too

much the weight of the door may pull the hinge and back plate apart. (If the hinge and back plate pull

apart, lift the door to remove stress and re-tighten the screws.)

If the door needs adjusting, loosen the screws located in the hinges (do not remove) one bracket at a

time and adjust the panel as needed.

When the door is properly aligned the bottom edge of the glass should be parallel with the bottom

track.

When the door is properly aligned, fully tighten the screws. Do not overtighten.

Hinge

Screws

5/32"

Hex Key

1064866-2-B 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

No comments

Kohler K-705704-L-NX Installation Guide Page 16