Kohler K-9516-PB Installation Guide download pdf (Page 6)

5. Install the Top Bracket

IMPORTANT! The slide bar must be mounted to stud framing

supports at both the top and bottom. Wall anchors will not support

the slide bar.

NOTE: This accessory should not be installed in the area 24″ (61 cm)

to 48″ (121.9 cm) from the ﬂoor (the critical support area as deﬁned

in ASTM F446).

Separate the top cover and housing by pulling ﬁrmly.

Remove the ring.

Press the tab, and separate the housing from the bracket.

Position the bracket on the ﬁnished wall, and mark the top

location of the centermost slotted hole.

Drill a hole at the marked location.

NOTE: Do not use wall anchors.

Position the bracket against the ﬁnished wall, and loosely attach it

to the ﬁnished wall with the provided screw and washer.

Fit the housing over the bracket, and snap it into place.

Tab

Bracket

Top Housing

Ring

Top Cover

Bracket

Slotted Hole

Front View

Washer

Screw

Top

Housing

089408-2-AC 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Kohler K-9516-PB Installation Guide Page 6