Kohler K-13472-VS Installation Guide download pdf (Page 5)

Troubleshooting

Symptoms Probable

Causes

Recommended Action

1. No water

ﬂow.

A. Filter is

plugged.

A. Clean or replace the ﬁlter.

B. Sensor eyes

are dirty.

B. Wipe the sensor eyes with a

damp soft cloth. Wipe dry with a

dry soft cloth.

C. Water not

turned on.

C. Verify that the water supply is

turned on and that pressure is at

least 20 psi (137 kPa).

D. Incorrect

installation.

D. Verify that the faucet is

mounted as instructed in the

installation guide. Ensure that the

sensor eyes are above the rim of

the lavatory. Refer to the

installation instructions.

E. The aerator

is plugged.

E. Remove and clean the aerator.

For calcium/mineral deposits, soak

the plastic insert in a 50:50 mix of

water and vinegar. Soak only the

plastic insert.

F. Sensor eyes

are scratched.

F. Replace the sensor assembly.

G. A ﬂex hose

is kinked.

G. Check the ﬂex hoses to make

certain they are not kinked. If a

ﬂex hose is kinked, disconnect it,

straighten, and reconnect.

H. Batteries

have just been

replaced.

H. Wait 2 minutes after replacing

batteries as the sensor cycles

through the automatic sensing

distance.

I. Battery life

expired.

I. Remove faucet from body and

replace batteries. Use two standard

AAA batteries.

J. Bleed hole

in diaphragm

is plugged or

debris exists

on the seal.

J. Clean or replace the diaphragm.

K. Solenoid is

broken.

K. Order a new solenoid service

kit.

Kohler Co. 5 1102759-2-B

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comments to this Manuals

No comments