Kohler K-2177-96 Installation Guide download pdf (Page 2)

1010422-2-A

2

Kohler Co., Kohler, WI U.S.A.

TOOLS AND MATERIALS

REQUIRED

 Level

 Drill with assorted bits

 Socket wrench and assorted sockets

 Tape measure

 Framing square

INSTALLATION

 Rough-in the supplies and drain

piping and trap.

NOTE: The supply stop handles cannot

extend more than 3-1/2” (8.9cm) from the

finished wall when in the open position.

 Install sufficient backing behind the

finished wall to provide a secure

material for the anchoring devices.

 Apply six self-adhesive gaskets

(provided) to the top edge of the

pedestal.

Gasket

Top of Pedestal

 Mark the centerline on the floor.

 Position the pedestal on the floor

centerline so the mounting hole is

approximately 6-13/16” (17.3cm) from

the finished wall.

 Carefully set the lavatory on the

pedestal.

 Move the pedestal as required to

ensure proper fit in the desired

location.

 Level the lavatory. Add more

self-adhesive gaskets as needed to

level the lavatory.

NOTE: The lavatory

must be

supported by the pedestal.

 Check the lavatory placement.

 Mark the center of each anchoring

hole on the wall, and mark the floor

through the hole in the pedestal

bottom.

 Carefully remove the lavatory from

the pedestal. Then move the pedestal

from the area.

Mark Floor

Here

Pedestal

Finished

Wall

Anchoring

Holes

1 2 3 4 5 6 7 ... 11 12

Comments to this Manuals

No comments