Kohler K-2177-96 Installation Guide download pdf (Page 3)

3

Kohler Co., Kohler, WI U.S.A.

1010422-2-

A

 Drill a 1/4” mounting hole at the mark

on the floor, then drill two 1/4” hanger

bolt holes at the marks on the wall.

 Mount hanger bolts to the wall so

approximately 3/4” (2cm) of each bolt

remains exposed.

NOTE: Other fastening devices of

sufficient size and strength may also be

used.

Finished Wall

Hanger

Bolts

 Install the faucet and drain to the

lavatory according to the

manufacturer’s instructions.

NOTE: Do not fully tighten slip-joint

drain connections at this time.

 Position the pedestal mounting hole

over the hole in the floor.

 Secure the pedestal to the floor with

the wood screw and washer. Tighten

the screw until it is snug.

CAUTION: Risk of product

damage. Do not overtighten.

Overtightening may cause damage to

the product.

Pedestal

Wood Screw

Washer

 Set the lavatory on the pedestal so the

hanger bolts extend through the

lavatory holes.

 Level the lavatory.

 Install the cap nuts and washers, and

tighten until snug.

CAUTION: Risk of product

damage. Do not overtighten the cap

nuts. Overtightening may cause

damage to the product.

 Connect and tighten the trap to drain.

Connect the hot and cold water

supplies to the faucet.

Finished

Wall

Hanger

Bolts

Cap Nut

Washer

Lavatory

Pedestal

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments