Kohler K-8973-7-BN Installation Guide download pdf (Page 12)

4. Construct the Tee Assembly - Freestanding

Thread the fastener support into the side of the bath with a 1/4″ hex wrench. Do

not overtighten.

Ensure the distance from the head of the fastener support to the bath surface is

approximately 1/2″ (1.3 cm).

Thread the fastener rod into the fastener support.

Thread a bracket onto one end of tee rod until hand-tight.

Slide the tee rod through the center hole of the tee.

Hand tighten the remaining bracket onto the other end of the tee rod to construct

the tee assembly.

Ensure the center-to-center distance between the brackets aligns with the

center-to-center distance of the installed riser tubes.

Slide the tee assembly down onto the installed riser tubes. Do not secure the tee

assembly at this time.

Construire le T - Autoportante

Visser le support de ﬁxation dans le côté de la baignoire avec une clé hexagonale

de 1/4″. Ne pas trop serrer.

S’assurer que la distance de la tête du support de ﬁxation à la surface de la

baignoire soit d’approximativement 1/2″ (1,3 cm).

Visser la tige de ﬁxation dans le support de ﬁxation.

Visser un support dans une extrémité de la tige T jusqu’au serrage à main.

Tee/T/T

Tee rod

Tige en T

Varilla de la T

Fastener Support

Support de fixation

Soporte de fijación

Fastener Rod

Tige de fixation

Varilla de fijación

1/2"

(1.3 cm)

Bracket

Support

Soporte

Bath

Baignoire

Bañera

Fastener Rod

Tige de fixation

Varilla de fijación

Fastener Support

Support de fixation

Soporte de fijación

1169172-2-A 12 Kohler Co.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Kohler K-8973-7-BN Installation Guide Page 12

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-8973-7-BN