Kohler K-11344-G-0 Installation Guide download pdf (Page 10)

6. Make the Electrical Connections – Canada

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

WARNING: Risk of electric shock. Connect the blower motor to a properly grounded,

grounding-type Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD). This

will provide additional protection against line-to-ground shock hazard.

Locate and secure each supplied junction box a minimum of 1-1/2″ (38 mm) above the subﬂoor.

The bath controls and system have been prewired at the factory. A qualiﬁed electrician should make

a routine service connection to the junction box.

Connect service to the junction box. The 60 Hz model junction box contains black and white wires

and a ground lug.

A 120 V, 15 A dedicated circuit is required. Provide a Class A GFCI or RCD.

Provide a separate equipment grounding conductor for the inside ground or ground lug. The

conductor must not be connected to any current-carrying conductor.

Bond in accordance with national and local codes.

The junction box should be

wired as shown.

Bond in accordance with

national and local codes.

Black

Supply

White

Electrician to

provide suitable

strain relief.

Blower Motor

Electrical Cord

Ground (Green with Yellow Stripe)

Wire Connectors

From Blower Motor

Black

N White

GND

Green with Yellow Stripe

1220597-2-A 10 Kohler Co.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

No comments

Kohler K-11344-G-0 Installation Guide Page 10