Kohler K-11344-G-0 Installation Guide download pdf (Page 9)

4. Install the Blower Motor

NOTE: Refer to the ″Before You Begin″ section for other detailed requirements for the blower motor

relocation.

At the new blower motor location, install a 1-1/2″ (38 mm) high block (not supplied) above the

ﬂoor to support the blower motor.

Fasten the blower motor to the support block with appropriate fasteners (not supplied).

Install the check valve at the blower motor location. The check valve must be oriented vertically.

Conﬁrm the check valve is oriented with the ﬂow arrow pointing away from the blower motor, and

is located no lower than 24″ (610 mm) below the bath rim.

Install and support PVC or other 1-1/2″ rigid piping (not supplied) between the blower motor

location and the airbath location.

At the bath end, provide a union or other serviceable connection to the existing blower hose.

Conﬁrm all wall holes are properly sealed and comply to local building and ﬁre codes.

Route the keypad cable from the new blower motor to the bath. Provide cable ties or other support

clips as needed.

Align and connect the keypad cable to the blower motor.

5. Make Electrical Connections - USA

WARNING: Risk of electric shock. Connect the blower motor to a properly grounded,

grounding-type receptacle protected by a Ground-Fault Circuit-Interrupter (GFCI) or Residual

Current Device (RCD). Do not remove the grounding pin from the plug. Do not use a grounding

adapter.

WARNING: Risk of electric shock. Disconnect the power before performing the following

procedures.

NOTICE: The blower motor is equipped with a cord and plug. A qualiﬁed electrician must install a GFCI-

or RCD-protected, 120 V, 15 A, grounded outlet for the blower. No other load should be on this circuit.

Install an electrical outlet behind the bath, at least 1-1/2″ (38 mm) above the subﬂoor, and within

reach of the 24″ (610 mm) power cord.

Plug the blower into the outlet.

Check Valve

Screw

Blower Motor Mounting Screws

(not supplied)

1-1/2" Rigid Piping

(not supplied)

1-1/2" (38 mm) Min

Kohler Co. 9 1220597-2-A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Kohler K-11344-G-0 Installation Guide Page 9