Kohler K-1357-VB-0 Installation Guide download pdf (Page 8)

3. Route the Cables

IMPORTANT! The cables that will connect the control ampliﬁer to the bath transducers, chromatherapy

control (if equipped), and the user interface are each 25’ (7.6 m) in length. Plan to position the control

ampliﬁer so these cables, when routed and connected, will easily reach without placing tension on the

cables.

The bath transducer cables are coiled and attached to the back of the bath.

Use a tin snips or shears to cut the cable tie securing the transducer cables.

Carefully route the transducer cables through the framing, drilling 1″ (52 mm) holes where needed,

to the planned control ampliﬁer location.

If equipped with chromatherapy lights, carefully route the chromatherapy cable from the

chromatherapy control on the bath to the planned ampliﬁer location following the same route as the

transducer cables.

Route the user interface cable through the framing from the planned user interface location to the

planned control ampliﬁer location following the same route as the transducer cables. Make sure the

larger Ethernet-style connector is at the control ampliﬁer end.

If used, route an auxiliary-in cable (not included) to the planned control ampliﬁer installation

location. This auxiliary connection can be used for pairing Bluetooth devices and other

battery-operated audio devices so users can play their own music with the vibracoustic bath.

1181167-2-E 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 55 56

No comments

Kohler K-1357-VB-0 Installation Guide Page 8