Kohler K-1418-G-0 Installation Guide download pdf (Page 17)

11. Complete the Installation

For Drop-In Installations

If you have not already done so, carefully remove the protective tape from the bath rim.

Cover the framing with water-resistant deck material. Seal the joints between the bath rim edge and

the water-resistant deck material with silicone sealant.

Install the faucet trim according to the instructions packed with the trim.

For Island Installations

If you have not already done so, carefully remove the protective tape from the bath rim.

Apply mortar and tile to any wall, deck, and surround material as needed.

Apply a bead of sealant where the tile meets the bath surface.

Install the faucet trim according to the instructions packed with the trim.

For All Installations

Clean the area around the blower motor of all dust and debris.

Use warm water and a liquid detergent to clean the surface of the bath. Do not use abrasive

cleansers, as they may scratch and dull the bath surface. Do not use powdered cleaners unless the

cleaner is fully dissolved in water. Solid substances could block the airjets. Do not use bleach or

ammonia cleaning solutions. Chemically active cleaning solutions can damage the bath surface.

Refer to the homeowners guide for normal cleaning recommendations.

12. Test Run the Bath

NOTE: If the bath is not operating properly, consult the ″Troubleshooting″ section of this guide before

calling a qualiﬁed service representative.

NOTE: For additional information on operating the bath, see the ″Operate User Keypad″ section.

Preliminary Checks

Temporarily remove all access panels.

Ensure that the area around the blower motor is free of sawdust, insulation, dirt, or other small

loose debris.

Verify the union connection at the check valve is securely hand tightened.

Verify the piping from the blower motor to the butterﬂy valves are properly connected and

supported.

Verify the piping from the check valve to the butterﬂy valves are properly connected and supported.

Bath

Framing

Finished Deck

Material

Apply silicone sealant to the edges

of the water-resistant deck

material and the finished deck.

Water-Resistant

Deck Material

Kohler Co. 17 1035472-2-H

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

No comments

Kohler K-1418-G-0 Installation Guide Page 17