Kohler K-99696-NA Installation Guide download pdf (Page 13)

Operation (cont.)

NOTE: If connected to a DTV+ system, the pin and device name

can be changed using the controller Web pages.

Upon receiving a wireless signal, the LED will turn solid blue and

the audio input will fade in.

Wireless input will override any signal that may be coming from

the front or back line-in ports.

3.5 mm Stereo Output

A line-out port is available to provide unampliﬁed stereo output

of the audio signal that can be fed to another external device.

Standby Mode

If no audio signal is detected for 30 seconds from the 3.5 mm

line-in ports, the ampliﬁer will go into standby mode and the

LED will turn yellow.

BLUETOOTH Standby: If no audio signal is detected for 30

seconds from a connected wireless device, the ampliﬁer will go

into BLUETOOTH standby mode and the LED will change from

solid blue to blue blink.

DTV+ Operation

For information on operating the ampliﬁer using the DTV+

system, refer to the guide on the K-99695 controller product page

at www.us.kohler.com.

Troubleshooting

IMPORTANT! Turn off the power supply before performing any

maintenance.

NOTE: For DTV+ system troubleshooting, refer to the guide on

the K-99695 controller product page at www.us.kohler.com.

NOTE: For service parts information, visit your product page at

www.kohler.com/serviceparts.

This troubleshooting guide is for general aid only. For service and

installation issues or concerns, call 1-800-4KOHLER.

Kohler Co. 13 1232038-2-B

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

No comments

Kohler K-99696-NA Installation Guide Page 13