Kohler K-T16248-4-BN Installation Guide download pdf (Page 4)

2. Install the Spout Supply Tube

Remove the plaster guard from the spout supply tube.

Ensure that the spout supply tube projects a minimum of 1-1/4”

(3.2 cm) above the ﬁnished deck.

Using a ﬁle, remove all burrs from the spout supply tube. This

will prevent damage to the O-ring inside the sleeve.

For tile-covered deck installations: With the ﬂat side of the

washer facing the edge of the ﬁnished deck (as shown), slide the

washer onto the spout supply tube. For all other installations:

Discard the brass washer.

NOTE: Before installing the spout sleeve assembly, make sure the

O-ring is properly positioned in the groove on the outside of the

sleeve.

Loosen the setscrews in the spout sleeve assembly.

Using a twisting motion, slide the spout sleeve assembly onto the

spout supply tube until it contacts the ﬁnished deck.

Align the spout sleeve assembly with the setscrews offset from

the center (not facing directly forward or backward) of the spout

supply tube.

Retighten the setscrews.

Purge the spout supply tube of debris.

1-1/4"

(3.2 cm)

Finished

Deck

Setscrews

Spout Sleeve

Assembly

Finished

Deck

Washer

Spout

Supply Tube

1054538-2-C 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Kohler K-T16248-4-BN Installation Guide Page 4