Kohler K-T398-4-SN Installation Guide download pdf (Page 4)

2. Install the Spout

CAUTION: Risk of product damage. Use care when installing

the spout assembly to prevent damage to the O-ring seal.

NOTE: If your installation is on a tile-covered rough deck, slide a

brass washer, ﬂat side facing forward, onto the supply tube. The

brass washer is supplied with the spout. This washer is not needed

for rim/ﬁnished deck installations.

Remove the plaster guard from the spout supply tube.

Cut off the spout supply tube 1-1/2″ (3.8 cm) above the

escutcheon.

Remove all burrs from the supply tube.

Loosen the setscrews in the sleeve.

Using a twisting motion, install the sleeve on the spout supply

tube until it contacts the deck or washer.

Align the sleeve with the setscrews offset from the center (not

facing directly forward or backward) of the supply tube.

Tighten the setscrews.

Position the spout on the sleeve, and carefully press down until

the spout contacts the ﬁnished deck.

Align the spout as desired, and tighten the setscrew.

Insert the plug button (if included) over the setscrew, ﬂush with

the spout surface.

Setscrews

Setscrew

Sleeve

Escutcheon

Plug Button

Spout

Assembly

Finished

Deck

1012740-2-E 4 Kohler Co.

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Kohler K-T398-4-SN Installation Guide Page 4