Kohler K-2035-1-58 Installation Guide download pdf (Page 5)

2. Install the Angle Brackets

NOTE: This product is heavy. Get help when lifting and securing

the sink and shroud.

With assistance, carefully lift the sink into place on the hanger

bracket and level the sink. Adjust the hanger bracket as needed.

On the underside of the sink, locate and mark the sink anchor

holes on the ﬁnished wall.

Apply six self-adhesive gaskets to the top of the shroud as

shown.

With assistance, carefully position and center the shroud tight

against the underside of the sink. Mark the three shroud hole

locations on the ﬁnished wall.

Carefully remove the shroud and sink.

Draw a level line connecting the top shroud hole marks. Measure

2-1/8″ (54 mm) on each side of the centerline to mark the top two

angle bracket holes.

For the bottom angle bracket hole, measure and mark the

centerline 1-5/8″ (41 mm) above the bottom shroud hole mark.

Lag Bolt

Sink Anchor

Holes

1-5/8"

(41 mm)

Angle Bracket

Holes

Sink Anchor

Holes

2-1/8" (54 mm)

2-1/8"

(54 mm)

Self-Adhesive

Gaskets

Kohler Co. 5 1015627-2-D

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Kohler K-2035-1-58 Installation Guide Page 5