Kohler K-1110-G-0 Installation Guide download pdf (Page 16)

10. Make Supply Power Connections - Remote

WARNING: Risk of electric shock. To reduce the risk of electric shock, connect the control to a

properly grounded Ground-Fault Circuit-Interrupter (GFCI) or Residual Current Device (RCD). This

will provide additional protection against line-to-ground shock hazard. A dedicated 220-240 V, 15 A,

50/60 Hz circuit is required.

WARNING: Risk of electric shock. Make sure the power has been disconnected before performing

the following procedures.

NOTE: The model number and electrical rating for the bath is printed on a label near the bath blower

motor.

Ensure that the control power supply cord is properly routed to the control power junction box. The

control power supply cord contains a brown wire (Line 1), a blue wire (Line 2), and a green wire

with a yellow stripe (ground or earth).

Install a strain relief (not provided) for the power supply cable to the control power junction box.

Route the power supply cable to the control power junction box.

As required, strip the jacket and wire insulation on both cables to make the connections.

For installations in the United States, mark any white conductor in the supply power wiring with

red or black tape as required by the NEC.

Connect service to the control power junction box.

Provide a separate equipment earthing or grounding conductor to the spare earth/ground lug

located on the control power junction box. This conductor must not be connected to any

current-carrying conductor. Follow local electrical codes.

Bond in accordance with national and local codes.

Clean the area of all dust and debris.

All wiring harnesses have been pre-wired at the factory. Ensure that all wires are securely fastened.

NOTE: Your wiring harness includes an antenna for the optional remote control. Do not alter or damage

this antenna during installation.

Power Supply Cable

Blower Motor Cord

Control Power Supply

Control Power Junction Box

Second Junction Box

(added for Remote Blower)

Check Valve

New Field Cable To Blower Motor

Typical Remote Blower Installation

Remote Blower

1035472-2-J 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 71 72

No comments

Kohler K-1110-G-0 Installation Guide Page 16