Kohler K-1110-G-0 Installation Guide download pdf (Page 6)

1. Construct the Site - Wood Frame

CAUTION: Risk of property damage. Do not support the bath by the rim. The bath must be

supported by the leveling blocks only.

NOTICE: Adequate ﬂoor support must be provided. Consult the roughing-in sheet packed with your bath

for speciﬁc ﬂoor loading requirements.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1″ (2.5 cm) from the wall or other objects.

NOTE: This bath may be installed in a drop-in or an island installation. An island installation requires a

four side surround.

Make sure the ﬂooring offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

For a drop-in installation: Carefully lay out and cut the rough deck material. Use the cut-out

template if one is provided, or refer to the roughing-in cutout information.

For an island installation: Construct a 2x4 frame in accordance with the roughing-in information

packed with the bath.

Provide access panels as required to service the blower motor and control.

Position the plumbing according to the roughing-in information. Cap the supplies, and check for

leaks.

Access

Panel

Frame the floor

according to the

roughing-in information.

Construct 2x4 or 2x6 stud

framing according to the

roughing-in information.

Position the

rough plumbing.

Verify that the subfloor

offers adequate support,

and is flat and level.

1035472-2-J 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 71 72

No comments

Kohler K-1110-G-0 Installation Guide Page 6