Kohler K-2449-F2 Installation Guide download pdf (Page 3)

1. Wall Preparation

NOTE: When notching the studs, the 3/4″ plywood should be no

bigger than 9″ (22.9 cm) in height to maintain structural integrity.

Measure and mark 33″ (83.8 cm) up from the ﬂoor. This will be

the height from the top of the 3/4″ plywood backing material to

the ﬂoor.

Notch the studs so the front of the 3/4″ plywood will be ﬂush

with the edge of the studs.

IMPORTANT! The backing should be at least 30″ (76.2 cm) long and

be aligned with the vanity.

Secure the 3/4″ plywood backing material to the studs with

framing nails.

Install the water supply and drain lines according to the

roughing-in information provided with your lavatory. The water

supply nipples must extend at least 3″ (7.6 cm) beyond the

ﬁnished wall material.

NOTE: Plumbing will be exposed and visible once the vanity

installation is complete. Chrome plumbing ﬁttings are

recommended.

Complete the ﬁnished wall. Ensure the ﬁnished wall is straight

and plumb, and the ﬂoor is ﬂat and perpendicular to the ﬁnished

wall.

3/4" Plywood

33"

(83.8 cm)

9" (22.9 cm)

30" (76.2 cm) Min

Kohler Co. 3 1061207-2-A

1 2 3 4 5 6 7 8 ... 31 32

No comments

Kohler K-2449-F2 Installation Guide Page 3