Kohler Command CV730 User Manual Page 135

  • Download
  • Add to my manuals
  • Print
  • Page
    / 217
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 134
8.19
8
Section 8
Electrical System and Components
3. Plug the tester into the proper AC outlet/power
supply for tester being used. Turn on the power
switch. See Figure 8-26. The ‘‘POWER’’ light
should be illuminated and one of the four status
lights may be on as well. This does not represent
the condition of the part.
Figure 8-27.
a. If the “OK” (green) light comes on and stays
steady, the part is good and may be used.
b. If any other light is displayed,* the rectifier-
regulator is faulty and should not be used.
*NOTE: A flashing “LOW” light can also occur as a
result of an inadequate ground lead
connection. Make certain connection location
is clean and clamp is secure.
Figure 8-26.
4. Press the ‘‘TEST’’ button until a “click” is heard
and then release. See Figure 8-27. Momentarily
one of the four status lights will illuminate,
indicating the condition of the part.
20/25 Amp Rectifier-Regulators
1. Connect the single lead adapter in between the B+
(center) terminal of the rectifier-regulator being
tested and the squared single end of the tandem
adapter lead. See Figure 8-28.
Figure 8-28.
2. Connect the tester ground lead (with spring
clamp) to the body of the rectifier-regulator.
3. Connect the red lead and one of the black leads to
the pair of terminals on the open end of the
tandem adapter lead (connections are not location
specific).
4. Connect the remaining black lead from the tester
to one of the outer AC terminals on the rectifier-
regulator. See Figure 8-29.
Figure 8-29.
5. Plug the tester into the proper AC outlet/power
supply for tester being used. Turn on the power
switch. The ‘‘POWER’’ light should be
illuminated and one of the four status lights may
be on as well. See Figure 8-26. This does not
represent the condition of the part.
Page view 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 216 217

Comments to this Manuals

No comments