Kohler Command CV730 User Manual download pdf (Page 46)

5.12

Section 5

Fuel System and Governor

Figure 5-10. Typical Carburetor - Exploded View.

Inspection/Repair

To clean vent ports, seats etc., use a good

commercially available carburetor solvent, such as

Gumout™, and clean, dry compressed air to blow out

internal channels and ports. Use a suitable shop rag to

prevent debris from hitting someone.

Carefully inspect all components and replace those

that are worn or damaged.

• Inspect the carburetor body for cracks, holes and

other wear or damage.

• Inspect the float for cracks, holes, and missing or

damaged float tabs. Check the float hinge and

shaft for wear or damage.

• Inspect the fuel inlet needle and seat for wear or

damage.

• Inspect the tip of the low idle fuel adjusting

needle (if equipped), for wear or grooves.

• The choke plate is spring loaded. Check to make

sure it moves freely.

1. Carburetor Body

2. Idle Fuel Adjusting Screw*

3. Idle Fuel Adjusting Spring*

4. Passage Cover

5. Cover Gasket*

6. Cover Retaining Screw

7. Main Jet

8. Ground Lead (Solenoid only)

9. Fuel Bowl Gasket

10. Float Kit

11. Fuel Bowl

12. Bowl Retaining Screw Gasket

13. Bowl Retaining Screw

14. Shut-off Solenoid Assembly

15. Throttle Shaft/Lever

16. Throttle Plate

17. Choke Shaft

18. Choke Plate

19. Air Filter

20. Collar

21. Spring

22. Ring

23. Choke Lever

24. Idle Speed Screw

25. Idle Speed Spring

26. Setscrews (Plates - 4)

*Included in Carburetor Repair Kit.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 216 217

Comments to this Manuals

No comments

Kohler Command CV730 User Manual Page 46

Comments to this Manuals

Related products and manuals for For the car Kohler Command CV730