Kohler 3.5CFZ User Manual download pdf (Page 51)

TP-5695 12/93 Scheduled Maintenance 3-23

Wattage Requirements

Iftheratedcapacityofthegeneratorsetisexceeded,the

circuitbreakerlocatedonthecontrollerwilltriptoprotect

the generator against damage. Tripping could be

caused by a short in the AC circuit in the craft or simply

by having too many appliances on at the same time

resulting in an overload condition. If the circuit breaker

trips, the set may continue running but there will be no

AC output to the protected circuit. Before resetting the

circuitbreaker,turnoffsomeoftheappliancesandlights

inside the craft to bring the load down within the rated

limitsoftheset.Ifthisisdoneandthecircuitbreakertrips

again after being reset, see a qualified electrician.

For more information regarding generator set capacity,

see Installation—Generator Selection and Wattage

Requirements.

Generator Service

General

Under normal conditions generator service will not be

requiredon aregularbasis. Ifoperatingunder dustyand

dirty conditions, use DRY compressed air to blow dust

outofthegeneratoratfrequentintervals.Dothiswiththe

generator set operating and direct the stream of air in

through the cooling slots at the end of the generator.

The end bracket bearing should be replaced every

10,000 hours of operation. Have bearing replaced

sooner if bearing inspection indicates excessive rotor

end play or bearing damage from corrosion or heat

buildup.Theend bracket bearing is sealed andrequires

no additional lubrication. All generator service must be

performed by an authorized service dealer/distributor.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 80 81

No comments

Kohler 3.5CFZ User Manual Page 51