Kohler K-T10278-4A-G Installation Guide download pdf (Page 14)

8. Install Handles

NOTE: There are different handle styles available for this product.

Only the sculpted handle is shown. Installation of all handle styles

is identical.

Remove the plaster guards from the hot and cold valves.

Measure the distance from the top of the valve stem to the ﬁnished

surface.

For a valve stem height between 1–13/16” (4.6cm) and 2–1/8”

(5.4cm) use a brass spline adapter and screw. For a valve stem

height between 2–1/8” (5.4cm) and 2–5/16” (5.9cm) use a plastic

spline adapter.

If the brass spline adapter is required, attach using the screw

supplied. The plastic spline adapter slides on with no attachment.

Thread the handle onto the valve body. Ensure that the splines in

the handle and spline adapter are engaged.

Position the handle assemblies facing in opposite directions away

from the spout.

NOTE: The spline adapter allows ﬁne adjustment of the handle

alignment. To adjust, unthread the handle and reposition the spline

adapter. Rethread the handle and check alignment. Repeat until

handle alignment is satisfactory.

Handle

Plumbers

Putty

Screw

Brass

Spline

Adapter

Valve

Stem

Height

Measurement

Plastic

Spline

Adapter

Valve Stem

Valve Body

Threaded

Sleeve

Finished

Surface

Hot

Cold

Orientation Of Handles

In Off Position

1017937-2-A 14 Kohler Co.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments

Kohler K-T10278-4A-G Installation Guide Page 14

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-T10278-4A-G