Kohler K-T10278-4A-G Installation Guide download pdf (Page 9)

4. Complete Installation on Rough Deck

Set Valve Body Height

NOTE: Use one of the following two formulas to calculate the valve

body clearance required for the ﬁnish material at your site.

For tile that is less than 1” (2.5cm) thick, add 1–1/4” (3.2cm) to the

tile thickness. Example: Tile thickness is 3/4” + 1–1/4” = 2” (5cm) of

clearance required.

For tile that is between 1” (2.5cm) and 1–1/4” (3.2cm) thick, add

only 1” (2.5cm) to the tile thickness. Example: Tile thickness is

1–1/4” + 1” = 2–1/4” (5.7cm).

Adjust the threaded collar until the dimension from the top of the

sleeve to the top of the rough deck equals the clearance requirement

needed. Make a note of this dimension. You will use it again after

connecting the supply tube.

Connect Supply Tube

Measure the distance from the bottom of the spout supply tube to

the top of the tee.

Add 1” (2.5cm) to this measurement and cut a piece of copper

tubing to ﬁt into the supply tube and tee port.

Fully loosen the threaded collars but do not remove them.

Cold

Supply

Solder

Hot

Supply

Tee

Solder

Copper

Tube

Top Of Sleeve

1-1/4" (3.2cm)

Nominal

2" (5cm)

Clearance

3/4"

(2cm)

Mounting

Nut

2-1/8"

(5.4cm)

Max.

Tile

Thickness

Threaded

Collar

Spout Supply Tube

Sleeve

Valve

Body

Rough

Deck

Measure

Distance

Kohler Co. 9 1017937-2-A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Kohler K-T10278-4A-G Installation Guide Page 9

Comments to this Manuals

Related products and manuals for Sanitary ware Kohler K-T10278-4A-G