Kohler K-T10278-4A-G Installation Guide download pdf (Page 6)

Installation on Finished Deck or Rim (cont.)

Install Valve Bodies

Thread one mounting nut, ﬂange side up, followed by one ﬁber

washer and one rubber washer onto each valve body.

Insert the 2–7/8” (7.3cm) long copper tubes between the valve

bodies and the 1/2” tee. Insert the 2–3/8” (6cm) long copper tube

into the top of the tee.

Do not solder the connections at this time.

NOTE: The valve body marked “Cold” must be on the right side

when you are facing the front of the faucet.

Insert the valve bodies through the mounting holes from the bottom

of the deck/rim. Match the copper tube from the tee with the spout

supply tube. Hold in place.

Place a collar with the ﬂange side up, onto each valve body. Thread

the collar down to at least 1” (2.5cm) from the top thread on the

valve body.

Install a threaded sleeve fully onto each valve body.

Thread each collar until it contacts the sleeve.

Tighten the mounting nuts on each valve body from underneath the

deck/rim.

Solder the copper tubes to the valve bodies, tee and spout supply

tube.

Ensure that the cold supply is on the right side.

Solder the hot and cold water tubes to the valve body inlets.

Proceed to Check Operation of Valves.

1017937-2-A 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 47 48

No comments

Kohler K-T10278-4A-G Installation Guide Page 6