Kohler Electric Shower User Manual download pdf (Page 26)

26

Malfunction

Cause Remedy

No water or very

low flow rate.

No hot water from

shower, with the

knobs in any

position.

Other water outlets are

being used during

showering, causing the

water pressure to drop

below the minimum

required.

The water pressure is

below the minimum

required.

Shower

temperature

cycles between

hot and cold.

The temperature is set

too high. This is causing

the thermal switch to

turn off the heating

element to reduce the

water temperature.

Clean the handset sprayplate.

Refer to the Maintenance

section of the handset manual.

The handset sprayplate

is blocked.

The incoming water

supply stop valves, or

the appliance isolating

valve, is closed.

The power is off at the

double pole switch.

Open the stop/isolating valve

completely.

Clear the blockage or replace

the hose or handset.

Switch on the power at the

double pole switch.

The hose or handset is

blocked.

Renew the fuse or reset the

MCB/RCD. If the fault persists,

contact the shower installer.

The fuse is blown or the

MCB/RCD has been

tripped, indicating a

possible electrical fault

Ensure the other water outlets,

such as the washing machine or

dishwasher, are not in use

during showering.

Ensure that the incoming water

supply stop and the isolating

valve are completely open. If

the fault persists, contact the

shower installer.

Contact installer to replace

faulty parts.

Failure of pressure switch,

micro switch or thermal

switch.

Turn the temperature knob

anticlockwise to reduce the

water temperature.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Comments to this Manuals

No comments