Kohler K-7437-K-CP Installation Guide download pdf (Page 8)

6. Complete Drain Installation - Style A

For regular installations, insert the short end of the rod into the

body seal hole and under the stopper. For vandal-resistant

installations, ﬁt the rod through the hole in the stopper. Secure

with the body nut.

Remove and adjust the stopper so it lifts about 3/8″ (1 cm) when

opened. To adjust, loosen the stopper nut and shorten or lengthen

the stopper as needed. Tighten the stopper nut.

Apply three layers of thread tape and a small bead of pipe

sealant to the tailpiece threads.

Thread the tailpiece to the body and tighten securely.

Slide one end of the clip onto the rod. Slide the link onto the rod

with the thumbscrew facing the back of the ﬁxture.

Squeeze the other end of the clip, aligning the hole with the rod.

Move the link to the proper position by squeezing the clip and

sliding it along the rod.

Insert the lift rod into the hole in the faucet and then into the

hole in the link.

Tighten the thumbscrew onto the link so the lift rod knob extends

above the lift rod hole.

Body Nut

Stopper

Body

Tailpiece

Seal

Seal Hole

Rod

Apply 3 layers of

sealant tape and a

small bead of pipe

sealant to threads.

Stopper

Nut

Faucet

Rod

Clip

Thumb

Screw

Link

1006847-2-C 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

No comments

Kohler K-7437-K-CP Installation Guide Page 8