Kohler Command CV730 User Manual download pdf (Page 113)

7.1

Section 7

Retractable Starter

Section 7

Retractable Starter

WARNING: Spring Under Tension!

Retractable starters contain a powerful, recoil spring that is under tension. Always wear safety goggles when servicing retractable

starters and carefully follow instructions in this section for relieving spring tension.

Handle with

Rope Retainer

Drive Cup

Starter Housing

Rope

Pawl Springs

Pawls

Pawl Retainer

Plain Washer

Center Screw

Brake Spring

Brake Washer

Pulley

Spring and

Keeper

Hex

Flange

Screws

Figure 7-1. Retractable Starter – Exploded View.

To Remove Starter

1. Remove the five hex flange screws securing the

starter to the blower housing.

2. Remove the starter.

To Install Starter

1. Install the retractable starter onto the blower

housing leaving the five hex flange screws

slightly loose.

Figure 7-2. Removing Starter Handle.

3. Remove the rope retainer from inside the starter

handle. Untie the single knot and remove the

rope retainer and handle.

4. Hold the pulley firmly and untie the slipknot.

Allow the pulley to rotate slowly as the spring

tension is released.

5. When all spring tension on the starter pulley is

released, remove the rope from the pulley.

2. Pull the starter handle out until the pawls

engage in the drive cup. Hold the handle in this

position and tighten the screws securely.

Rope Replacement

The rope can be replaced without complete starter

disassembly.

1. Remove the starter from the blower housing.

2. Pull the rope out approximately 12 in. and tie a

temporary (slip) knot in it to keep it from

retracting into the starter. See Figure 7-2.

Slipknot

Handle

Knot

Rope Retainer

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 216 217

Comments to this Manuals

No comments

Kohler Command CV730 User Manual Page 113

Comments to this Manuals

Related products and manuals for For the car Kohler Command CV730