Kohler K-2035-1-58 Installation Guide download pdf (Page 7)

3. Install the Sink and Shroud

IMPORTANT! The sink must be supported by the hanger bracket.

Drill 1/4″ sink anchor holes at the marked locations.

Carefully set the sink on the hanger bracket. Level the sink.

Install the faucet and drain to the sink according to the

manufacturer’s instructions.

Connect and tighten the trap to the drain. Complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

NOTICE: Risk of product damage. Vitreous material can crack or

chip. Do not overtighten the hanger bolts or angle bracket screws.

Carefully position the shroud under the sink.

Partially thread the angle bracket screws. For a snug ﬁt against

the sink, tighten the bottom screw ﬁrst. Then, use an offset

screwdriver to tighten the top screws. Do not overtighten!

Thread the bolt caps onto the hanger bolts. Secure the sink to the

wall with the hanger bolts and washers. Tighten until snug. Do

not overtighten!

Washer

Hanger Bolt

Angle Bracket

Screw

Bolt Cap

Offset

Screwdriver

Sink Anchor

Holes

Kohler Co. 7 1015627-2-D

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Kohler K-2035-1-58 Installation Guide Page 7