Kohler K-1154-47 Installation Guide download pdf (Page 18)

Troubleshooting Procedure (cont.)

Symptoms Probable Causes Recommended Action

B. Remove the access panel and

press the air switch, if you do not

hear a ″click,″ the air switch

tubing is loose or disconnected.

B. Check if the air switch tubing is

connected at both the

receiver/pump end and the air

switch. Reconnect if needed.

C. Air switch tubing is pinched or

kinked.

C. Adjust tubing to clear the

pinched/kinked area. If the

pinch/kink cannot be ﬁxed, or

no noticeable pinch/kink is

apparent, puncture the tubing

with a tack and try the system

again.

D. Push button assembly is damaged. D. Replace the push button

assembly.

E. Pump has power and a ″click″ is

heard when the air switch is

pressed. Pump is defective.

E. Replace the pump.

F. The receiver in the pump is

defective.

F. Replace the receiver or pump.

G. System has a timer kit and the

pump is not switched to the ON

position.

G. Refer to the timer kit installation

instructions.

2. The system will start but

will not stay ON.

A. The receiver in the pump is

defective.

A. Replace the receiver or pump.

3. Whirlpool stops

automatically.

A. System includes an integral timer

and will turn off automatically

after 18 minutes.

A. Verify your system has an

integral timer, if yes, no

additional action is needed.

B. Pump has overheated and the

protection devices has activated.

B. Check for blockage at the motor

vents. Check for suction

blockage. Check for jet blockage.

Remove any blockage and allow

the motor to cool.

C. GFCI/ELCB circuit has tripped. C. Identify source fault and correct.

Check that the GFCI/ELCB has

not been tripped. If problem

persists, contact an electrician.

4. The motor starts but not

all jets fuction.

A. Jets are closed. A. Rotate the jet trim ring

counterclockwise to

open/increase ﬂow to the jets.

B. Jets are blocked or trim ring

rotation is impeded.

B. Glue may be obstructing the jet

opening or preventing the jet

trim ring from rotating. Remove

the trim ring and remove excess

glue.

C. Jets not installed correctly. C. Reinstall the jet; check for any

O-ring damage.

D. Pump is not supported correctly

and is cavitating.

D. Review the installation

instructions and verify that the

pump is a the appropriate height

and tat the pump banding straps

(when applicable) have been cut.

5. Noisy pump operation. A. The pump banding straps have

not been cut (models with support

blocks only).

A. Using tin snips, cut pump

banding straps.

6. Heater does not operate

(units with heaters only).

A. No power to heater or it is not

connected to a separate outlet

from the pump.

A. Verify that the heater is

connected to a separate outlet

from the pump and that the

connection has power.

1010564-2-H 18 Kohler Co.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments

Kohler K-1154-47 Installation Guide Page 18

Comments to this Manuals

Related products and manuals for Space heaters Kohler K-1154-47