Kohler K-1418-V-0 Installation Guide download pdf (Page 8)

4. Install the Whirlpool Trim Kit

Install the Trim Kit

Install the suction cover and jets according to the instructions packed with the trim kit.

Install the Neckjet Trim (if included)

NOTE: The neckjets will not operate unless the pillow is installed. Always use a slip cover to prevent

water from spraying from the whirlpool.

Choose a slip cover, and ﬁt it over the pillow.

Carefully slide the pillow down onto the neckjet body grooves until it is secure.

Test Run the Whirlpool

Fill the whirlpool to a level at least 2″ (51 mm) above the top of the highest jet.

Operate the whirlpool for 5 minutes and check all whirlpool piping connections for leaks. Check for

leakage along the front, sides, and back of the whirlpool.

Turn on each of the whirlpool features and verify proper function. Check for water leakage along

the front, sides, and back of the whirlpool.

For additional information on whirlpool operation, see the ″Operating Instructions″ section.

Complete the Installation

Install water-resistant wallboard and all ﬁnished wall, deck, and ﬂoor materials.

Apply silicone sealant to seal all areas where the whirlpool and ﬁnished wall or deck meet.

Install the faucet trim.

Clean-up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the

whirlpool surface. If necessary, use warm water and a liquid detergent to clean the surface of the

whirlpool, user keypad, and remote control.

Remove stubborn stains or paint with turpentine or paint thinner. Do not allow cleaners containing

petroleum distillates to remain in contact with any whirlpool surface for long periods of time.

Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or

other metal tools. Use a powder-type detergent on a damp cloth to provide mild abrasive action to

any residual plaster.

Slide the O-Ring

onto the first shoulder

of the jet.

Housing

Inspect and lubricate

the O-Ring.

Insert the jet into the housing,

and lightly push and rotate until

it snaps in position.

Neckjet Body

Slide the pillow onto

the neckjet body.

Fit the slip cover

over the pillow.

1194657-2-A 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments

Kohler K-1418-V-0 Installation Guide Page 8

Comments to this Manuals

Related products and manuals for Unknown Kohler K-1418-V-0