Kohler K-16137-4-BV Installation Guide download pdf (Page 2)

105833-2-

AA (A)

Kohler Co., Kohler, WI

INSTALLATION

Install two 1/2” I.P.S. nipples on inlet and outlet piping to

extend to outside edge of finished wall.

Place wall bracket over nipples. Insert sleeves into wall

bracket and thread onto nipples. Tighten sleeves using

seat wrench or 7/16” square bar.

Install an O-ring on vacuum breaker inlet and outlet ports.

Lubricate O-rings to ease assembly.

Slide vacuum breaker inlet/output ports into sleeves in

wall bracket and secure with two socket head screws. Use

5/32” hex head wrench.

Fig. #2

1/2” I.P.S. Nipples

Wall Bracket

Sleeve

O-Ring

Socket

Head

Screw

Outlet Port

Inlet Port

1-3/8”

Vacuum Breaker

Body

Finished

Wall

Socket Head

Screw

NOTE: Do not install shroud until all construction and

rough installation is complete.

Place shroud over vacuum breaker with cut-out over

input/output ports and threaded pin through hole at top of

shroud.

Thread cover onto threaded pin until hand-tight.

Fig. #3

Cover

Slot

Shroud

Threaded Pin

1 2

VACUUM BREAKER 1
INSTALLATION 2

Comments to this Manuals

No comments

Kohler K-16137-4-BV Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Unknown Kohler K-16137-4-BV