Kohler K-1647-PC-BV Installation Guide download pdf (Page 5)

1. Prepare the Site

NOTE: This section continues the installation as described in the steam generator installation instructions.

Refer to the steam generator installation instructions guide for more information, if required.

NOTE: If two steam heads are required, ensure there is at least 12-1/2″ (31.8 cm) between the center of

each hole. The steam heads do not need to be located in the same area.

Install the ﬁnished wall material.

Mark the temporary pipe nipple at the location of the ﬁnished wall surface.

Remove the temporary pipe nipple from the elbow.

Drill or cut a 2-1/2″ (6.4 cm) hole centered around the elbow in the wall.

Wall Stud

2-1/2" (6.4 cm)

6" (15.2 cm) from Floor

Provide clearance

from wall.

Mark the nipple even

with finished wall.

Temporary

Nipple

Wall Stud

Kohler Co. 5 1045320-2-F

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Kohler K-1647-PC-BV Installation Guide Page 5