Kohler K-1663-G Installation Guide Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
Troubleshooting Guide (cont.)
Symptoms Probable Causes Recommended Action
3. Err 3 appears on the
control pad.
A. Down button is stuck. A. Reset the power at the breaker.
4. Err 4 appears on the
control pad.
A. Time button is stuck. A. Reset the power at the breaker.
5. Err 5 appears on the
control pad.
A. The float switch was tripped for
10 seconds. The generator is not
getting enough water.
A. Check the water supply for proper
flow and check that the water
supply to generator is turned on.
B. Water feed assembly is blocked. B. Remove and inspect the water feed
assembly in the generator.
C. Water supply to generator is
shut off.
C. Check for a clogged water line and
check that the water supply to
generator is turned on.
6. Err 6 appears on the
control pad.
A. The maximum heat has been
exceeded.
A. Shut off the system and allow it to
cool. Reset the power at the
breaker.
7. Err 7 appears on the
control pad.
A. Temperature button is stuck. A. Reset the power at the breaker.
8. Err 8 appears on the
control pad.
A. Clock button is stuck. A. Reset the power at the breaker.
9. Unit shuts off. A. Unit has been in operation for
more than 60 minutes. The unit
will time out.
A. Turn unit back on.
10. No steam is being
generated.
A. Piping (inlet and outlet) is not
properly attached.
A. Reattach the pipes properly.
B. Steam head is blocked. B. Remove the steam head (after
cooling) and check that the plunger
slides freely in the cap.
11. There is a continuous
flow of water from the
steam head. Water flow
during automatic purge
cycle is normal.
A. Water supply incorrectly
attached to steam generator.
A. Connect the water supply to the
proper inlet.
B. Water feed assembly is stuck. B. Remove and inspect the water feed
assembly in the generator.
Kohler Co. 7 1008020-2-E
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments