Kohler K-1665-G Installation Guide download pdf (Page 5)

2. Installation - Module Style

Drill a 3-7/8″ diameter hole (4″ diameter if 3-7/8″ hole saw is

unavailable) in the ceiling material at the proper spot.

Apply construction adhesive to the plywood attached to the light.

IMPORTANT! The light ﬁxture should be as close to center of the

hole as possible. If the light ﬁxture is too far off center, a gap may be

visible next to the trim ring.

Position the light on the shower module roof so the round carrier

receiver ﬁts in the hole in the module ceiling.

Conﬁrm that the light ﬁxture is properly positioned while the

adhesive cures.

Connect the Wires

Remove the cover plate from the junction box.

Remove one small knockout slug from the junction box.

Pass 110 V, 60 Hz supply cable through the knockout hole and

secure with a strain relief bushing (not provided).

NOTE: Use UL listed wire nuts to connect the wires.

Connect the ground ﬁxture (green) wire to the ground supply

line.

Connect the white wires to each other.

Connect the black wires to each other. Replace the cover plate.

Wire Nut

Plywood

Module

Ceiling

Junction

Box

Cover

Plate

Kohler Co. 5 1015878–2–B

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Kohler K-1665-G Installation Guide Page 5