Kohler K-1665-G Installation Guide download pdf (Page 7)

4. Installation - Wallboard Style

Lift the light ﬁxture into place. The bottom of the ﬁxture (large

ﬂat area) should be ﬂush with the bottom of the ceiling joists.

Make sure the light ﬁxture is ﬂat and level.

Extend the mounting rods until they are tight against the joists.

Pound the spike into the joist.

Fasten a nail or wood screw into the nail hole in each rod.

Connect the Wires

Remove the cover plate from the junction box.

Remove one small knockout slug from the junction box.

Pass 110 V, 60 Hz supply cable through the knockout hole and

secure with a strain relief bushing (not provided).

NOTE: Use UL listed wire nuts to connect the wires.

Connect the ground ﬁxture (green) wire to the ground supply

line.

Connect the white wires to each other.

Connect the black wires to each other.

Replace the cover plate.

Joists

Spike

Wirenut

Cover

Nail

Hole

Junction

Box

Kohler Co. 7 1015878–2–B

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Kohler K-1665-G Installation Guide Page 7