Kohler K-2200-0 Installation Guide download pdf (Page 6)

2. Install the Lavatory

CAUTION: Risk of personal injury or product damage. Handle

with care. Product can break, chip or cause injury if handled

carelessly. Get help lifting the lavatory.

Countertop Installations

Cut out the opening by carefully following the pencil line traced

from the template.

Temporarily set the lavatory into the countertop cutout to check

for ﬁt.

Remove the lavatory from the countertop.

Drill the faucet holes.

Install the faucet according to the manufacturer’s instructions.

Install the drain. For pop-up drains, use the custom linkage

provided with this lavatory instead of the linkage supplied with

the drain.

Install the custom linkage as shown. Adjust and/or bend the

linkage as required to achieve smooth, effective pop-up drain

operation. Only bend the linkage at the location shown.

Apply a 1/8″ (3 mm) bead of sealant around the countertop

cutout hole. Apply the sealant approximately 1/4″ (6 mm) away

from the cutout hole edge.

Set the lavatory into the countertop cutout. Use care to avoid

smearing the sealant bead. Wipe away any excess sealant with a

clean cloth.

Follow the instructions listed on the sealant label. Allow the

sealant to set for 30 minutes or more before proceeding.

Connect and tighten the trap to the drain, and complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Run water into the lavatory and check for leaks.

Bend here only.

Adjust here.

Lift Rod

Custom Linkage

1018373-2-B 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Kohler K-2200-0 Installation Guide Page 6