Kohler K-2804-30 Installation Guide download pdf (Page 6)

Install the Lavatory (cont.)

Connect and tighten the trap to the drain, and complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Run water into the lavatory and check for leaks.

Clean up with a non-abrasive cleaner.

Above-Counter Installations

Cut out the opening by carefully following the pencil line traced

from the template.

CAUTION: Risk of personal injury or product damage. Cast

iron lavatories are very heavy. Get help lifting the lavatory into

place.

Temporarily position the lavatory in the countertop cutout so the

“Kohler” logo is to the back.

Inspect for proper ﬁt.

Remove the lavatory.

Drill the faucet holes.

Install the faucet to the countertop according to the

manufacturer’s instructions.

Install the drain to the lavatory according to the drain installation

instructions.

Apply a 1/8″ (3mm) bead of sealant around the countertop

cut-out hole. Apply sealant about 1/4″ (6mm) away from the

cut-out hole edge.

Carefully position the lavatory in the countertop cutout so the

“Kohler” logo is to the back.

Use care to avoid smearing the sealant bead. Wipe away any

excess sealant with a clean cloth. Fill any voids as needed.

Allow the sealant to cure for at least 30 minutes before

proceeding.

Connect and tighten the trap to the drain, and complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Run water into the lavatory and check for leaks.

Clean up with a non-abrasive cleaner.

1018375-2-A 6 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Kohler K-2804-30 Installation Guide Page 6