Kohler K-6486-FD Installation Guide download pdf (Page 3)

1. Roughing-In and Preparation

IMPORTANT! Before installing this sink, verify the opening height

(A) is less than the apron height, and the distance to the top of the

doors (B) is greater than the apron height.

NOTE: For cabinets with ﬂat fronts (no false drawer openings),

proceed to the ″Prepare the Cabinet - Flat Front″ section.

Remove the false drawer front from your cabinet. Use care not to

damage the cabinet.

TIP: Apply painter’s tape to the cabinet to mark cuts and protect

cabinet surfaces when cutting.

Measure and mark 7/8” (22 mm) in from the outside edge of the

cabinet. Repeat for the other side.

Cut along each marked line until the cut extends slightly beyond

the top of the drawer opening/top rail of the cabinet.

Following the bottom edge of the rail, extend your cut until it

intersects with the previous cut. Repeat for the other side.

6-11/16"

(170 mm)

A = Top of Cabinet to Bottom of

Drawer Opening

B =

Drawer Opening

False Drawer Front

Apron

Top of Cabinet to Top of Doors

Rail

Center

Support

Rail

7/8" (22 mm)

Inside Wall

Cut Line

Kohler Co. 3 1217971-2-A

1 2 3 4 5 6 7 8 ... 35 36

No comments

Kohler K-6486-FD Installation Guide Page 3