Kohler K-16100-4-CP Installation Guide download pdf (Page 9)

7. Supply Connections

If the lavatory is not installed, install it at this time using the

lavatory manufacturer’s instructions. Allow enough space for

penetration of supply tubes into the supply stops. Cut the supply

tubes if necessary.

Connect the supply hoses to the supply stops. (Left is hot - right

is cold).

Tighten all connections.

8. Installation Checkout

Connect the P-trap.

Ensure that all connections are tight.

Remove the aerator by turning it counterclockwise.

Open the drain.

Turn on the main water supply and check for leaks. Repair as

needed.

Open both hot and cold valves and run water through the spout

for about a minute to remove debris. Check for leaks. Turn valves

off.

Remove any debris from aerator and reinstall.

Nut

Compression

Union

HOT

COLD

Spout

Aerator

Kohler Co. 9 1031181-2-A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Kohler K-16100-4-CP Installation Guide Page 9