Kohler Command CV730 User Manual download pdf (Page 165)

9.9

Section 9

Disassembly

Figure 9-30. Removing Flywheel Screen.

6. Remove the remaining hex flange screws securing

the blower housing. Note the one silver plated

screw used for the rectifier-regulator ground

strap or lead. Remove the blower housing. See

Figures 9-31 and 9-32.

Figure 9-32. Removing Blower Housing.

Figure 9-31. Rectifier-Regulator Ground Strap.

Ground Strap

Silver Screw

Figure 9-34. Removing Inner Baffles.

3. Remove the two remaining hex flange screws

from the breather cover.

4. Pry under the protruding edge of the breather

cover with a screwdriver to break the RTV or

gasket seal. See Figure 9-35. Do not pry on the

sealing surfaces as it could cause damage

resulting in leaks. Most engines use a formed

gasket rather than RTV sealant.

Remove Oil Sentry™

1. Disconnect the lead from the Oil Sentry™ switch.

2. Remove the Oil Sentry™ switch from the breather

cover. See Figure 9-33.

Figure 9-33. Removing Oil Sentry™ Switch.

Remove Inner Baffles and Breather Cover

1. Remove the four hex flange screws securing the

inner baffles to the crankcase.

2. Remove the inner (valley) baffles. See Figure

9-34.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 216 217

No comments

Kohler Command CV730 User Manual Page 165