Kohler Command CV730 User Manual download pdf (Page 196)

11.9

Section 11

Reassembly

Figure 11-28. Installing Supports for Metal Grass

Screen.

2. Tighten the supports with a torque wrench to

9.9 N·m (99 in. lb.). See Figure 11-29. The grass

screen will be installed to the supports after the

blower housing is in place.

Figure 11-30. Applying Camshaft Lubricant to

Bottom of Lifters.

3. Note the mark or tag identifying the hydraulic

lifters as either intake or exhaust and cylinder 1

or cylinder 2. Install the hydraulic lifters into

their appropriate locations in the crankcase. Do

not use a magnet. See Figure 11-31.

NOTE: Hydraulic lifters should always be

installed in the same position as before

disassembly. The exhaust lifters are

located on the output shaft (oil pan) side

of the engine while the intake lifters are

located on the fan side of the engine. The

cylinder numbers are embossed on the

top of the crankcase and each cylinder

head. See Figure 11-32.

Figure 11-29. Torquing Supports for Metal Screen

(Some Models).

Install Hydraulic Lifters

1. See “Servicing Hydraulic Lifters” in Section 10

for lifter preparation (bleed down) procedures.

2. Apply camshaft lubricant (see Section 2) to the

bottom surface of each lifter. See Figure 11-30.

Lubricate the hydraulic lifters and the lifter bores

in the crankcase with engine oil.

Figure 11-31. Installing Hydraulic Lifters.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 216 217

No comments

Kohler Command CV730 User Manual Page 196