Kohler Command CV730 User Manual download pdf (Page 215)

11.28

Section 11

Reassembly

Figure 11-89. Securing Air Cleaner Mounting

Bracket.

6. Two-Barrel Carburetor Models Only: Attach the

choke return spring to the bottom of the main

control bracket. See Figure 11-90.

Figure 11-90. Attaching Choke Return Spring (Two-

Barrel Carburetors).

Choke Return

Spring

Install Muffler

1. Install the port liners (if equipped). Install the

muffler and attaching hardware to the muffler

bracket. Torque screws to 9.9 N·m (88 in. lb.).

2. Install the hex flange nuts to the exhaust studs.

Torque hex flange nuts to 24.4. N·m (216 in. lb.).

Install Oil Cooler

If so equipped, the oil cooler can now be installed to

the engine. Two different styles are used, see Section 6.

1. Depending on style used, reverse the removal

procedure from Section 9.

2. Secure the cooler or adapter to the oil pan with

the oil filter nipple. Torque the oil filter nipple to

27 N·m (20 ft. lb.).

Install Oil Filter and Fill Crankcase with Oil

1. Prefill a new oil filter following the instructions in

Section 6.

2. Apply a thin film of clean oil to the rubber gasket

on the oil filter and thread the filter onto the

adapter nipple. See Figure 11-91.

3. Hand tighten the filter until the rubber gasket

contacts the adapter, then tighten the filter an

additional 3/4-1 turn.

Figure 11-91. Installing and Tightening Oil Filter.

4. Install the oil drain plug(s). See Figure 11-92.

Torque plug(s) to 13.6 N·m (10 ft. lb.).

Figure 11-88. Installing Upper Mounting Screws.

5. Torque the valve cover/mounting bracket screws

to the proper specification and torque sequence

listed under “Install Valve Covers” on page 11.19.

1 2 ... 210 211 212 213 214 215 216 217

No comments

Kohler Command CV730 User Manual Page 215