Kohler Command CV730 User Manual download pdf (Page 32)

4.4

Section 4

Air Cleaner and Air Intake System

Air Cleaner Components

Whenever the air cleaner cover is removed, or the

paper element or precleaner are serviced, check the

following:

Air Cleaner Element Cover and Seal - Make sure

element cover is not bent or damaged. Make sure the

rubber sleeve seal is in place on the stud to prevent

dust or dirt entry through the stud hole.

Air Cleaner Base - Make sure the base is secured

tightly to the carburetor and not cracked or damaged.

Breather Tube - Make sure the tube is attached to both

the air cleaner base and the oil separator.

NOTE: Damaged, worn or loose air cleaner

components can allow unfiltered air into the

engine causing premature wear and failure.

Tighten or replace all loose or damaged

components.

Figure 4-7. Base Plate Removal on Standard Type.

Disassembly/Reassembly - Standard Type

If the base plate on the standard type has to be

removed, proceed as follows:

1. Remove the air cleaner components from the base

(see Figure 4-5).

2. Remove the two hex flange nuts securing the

bracket, or spitback cup with seal and baffle (if

equipped) to base. If a plastic intake manifold is

used, remove the two lower base mounting

screws. See Figure 4-7.

3. Pinch the sealing collar on the breather hose and

push it down through the hole in the base.

Figure 4-8. Removing Base on Commercial Mower

Type Air Cleaner.

Disassembly/Reassembly - Commercial Mower Type

If the base has to be separated from the carburetor

proceed as follows:

1. Remove the air cleaner components from the air

cleaner base (see Figure 4-6).

2. Remove the two nuts holding the air cleaner base

to the carburetor (see Figure 4-8).

3. Remove the tube from the base.

4. Separate the base from the carburetor.

5. Reverse procedure to reassemble components.

Torque air cleaner base mounting nuts to

6.2-7.3 N·m (55-65 in. lb.).

4. Remove the base and gasket. Carefully feed the

breather hose through the base.

5. Reverse procedure to reassemble components.

Torque the two hex flange nuts to 6.2-7.3 N·m

(55-65 in. lb.) and the two lower M5 mounting

screws (where applicable) to 4.0 N·m (35 in. lb.).

Mounting

Nuts (2)

Breather Hose

Baffle

Seal

Lower Base

Mounting Screws

Base

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 216 217

Comments to this Manuals

No comments

Kohler Command CV730 User Manual Page 32

Comments to this Manuals

Related products and manuals for For the car Kohler Command CV730