Kohler K-8361-BN Installation Guide download pdf (Page 5)

1. Prepare the Site

NOTE: Required mounting plate locations vary by model. The wall may be higher

than 21-1/2″ (54.6 cm), but the hole for the mounting bracket must be a certain height

from the ﬂoor for your speciﬁc model. Refer to the illustration above for mounting

bracket locations.

Construct a 2x4 surround around the overﬂowing bath. For other bathing ﬁxtures,

reference the dimensions for your chosen installation.

For K-8359 only: depending on the design of the ﬁnished wall, the 2x4 may be cut

down to ﬁt ﬂush with the rough wall exterior and match the overﬂowing bath

outer rim height.

Locate the position on the surround framing where the spout will be mounted

and mark the side of the top and base 2x4.

From the base 2x4 mark, measure 3-1/4″ (8.3 cm) from the outside surface of the

surround framing. Mark this location on the ﬂoor.

Cut a 7/8″ (2.2 cm) hole for the stem mounting assembly.

Locate the height for the mounting plate hole according to the dimensions in the

illustration above for your speciﬁc model.

Drill a 1-1/4″ (3.2 cm) diameter by 2-1/4″ (5.7 cm) deep hole using the marked

location as the center point.

Spout Base Location

7/8" (2.2 cm) D. Hole

Emplacement de la base du bec

Orifice Ø 7/8" (2,2 cm)

Ubicación de la base del surtidor

Orificio de 7/8" (2,2 cm) D.

K-8359

K-8361

K-8362

3-1/4" (8.3 cm)

Mounting Plate Location

1-1/4" (3.2 cm) D. Hole

Emplacement de la plaque de fixation

Orifice drain Ø 1-1/4" (3,2 cm)

Ubicación de la placa de montaje

Orificio de 1-1/4" (3,2 cm) D.

= 20-1/2" (52.1 cm)

= 16-5/8" (42.2 cm)

= 18-5/8" (47.3 cm)

Mark here.

Marquer ici.

Marque aquí.

Kohler Co. 5 1089448-2-A

1 2 3 4 5 6 7 8 9 10 ... 19 20

No comments

Kohler K-8361-BN Installation Guide Page 5