Kohler K-9530-BGD Installation Guide download pdf (Page 2)

Tools and Materials

Before You Begin

WARNING: Risk of personal injury. This product is a

diverter valve only and should never be used as a shut-off

valve. Doing so would allow cross ﬂow between the hot and

cold water supplies and create a serious scalding hazard.

Observe all local plumbing and building codes.

Shut off the main water supply.

Provide an access panel for all installations.

Carefully read this entire instruction manual before beginning the

installation; the illustrations do not show all possible

conﬁgurations.

This diverter can be installed to decks with a maximum thickness

of 1-1/4″ (32 mm).

Carefully inspect waste and supply tubing for any sign of

damage. Replace if needed.

You can extend the distance between the water source and the

braided hose connection with 1/2″ copper piping below the rim

of the bath/whirlpool, but it may not be safe or practical. A long

run of piping will mean a long run of room-temperature standing

water when the handshower is ﬁrst activated for use.

This diverter can be used in either a deck-mount or wall-mount

installation. Refer to the ″Diverter Conﬁgurations″ section for any

special considerations.

Do not install spouts with ﬂow restrictors or handheld shower

units on the large (5/8″ OD) bath outlet.

• Supply piping,

connectors, and caps

Plus:

Adjustable

Wrench

Tape

Measure

3/32" Hex

Wrench

Solder

Propane

Torch

Drill and

Hole Bit

1229813-2-A 2 Kohler Co.

1 2 3 4 5 6 7 ... 39 40

No comments

Kohler K-9530-BGD Installation Guide Page 2