Kohler K-1166-C1-96 Installation Guide download pdf (Page 8)

3. Install the Rough Plumbing

IMPORTANT! Choose a ﬁll spout which will provide a minimum 2″ (5.1 cm) air gap above the basin rim

of the overﬂowing bath. In addition, if you plan to install a deck-mounted, hand-held shower, the diverter

vacuum breaker must maintain a minimum 1″ (2.5 cm) air gap above the bathing well rim of the

overﬂowing bath.

Position the plumbing. Position the ﬁll spout supply so the spout will reach beyond both the outer

rim and the bathing well rim. Water from the ﬁll spout must be directed into the bathing well to

ﬁll the overﬂowing bath. The overﬂowing bath should never be ﬁlled by directing water into the

overﬂow channel.

Cap the supplies, and check for leaks.

4. Prepare the Unit

Carefully lift the overﬂowing bath out of the carton.

Identify the box located inside the overﬂow channel. This box contains the metal suction screen, and

must be saved for use with this product.

Install the drain according to the drain manufacturer’s instructions. Do not connect the trap at this

time.

Position a clean drop cloth or similar material in the bottom of the bath. Be careful not to scratch the

surface of the overﬂowing bath.

Bathing Well Rim

Bathing Well

2" (5.1 cm) Min

Outer Rim

1054216-2-B 8 Kohler Co.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

No comments

Kohler K-1166-C1-96 Installation Guide Page 8