Kohler K-5702-GW-0 Installation Guide download pdf (Page 7)

3. Prepare the Bath

NOTICE: Refer to the drain instructions to dry ﬁt to the bath. Do not cement and complete the drain

installation until instructed to do so.

Dry ﬁt the drain and overﬂow assembly to the bath. Refer to the drain instructions. Do not apply

sealant or cement to the drain components at this time.

Temporarily position a 2x4 in the installation area to support the bottom of the bath opposite the

drain.

With help, position the bath (without the shroud) and drain assembly over the drain pipe. Trim the

drain pipe as needed.

Loosen the drain and overﬂow connections from the bath.

Remove the bath, leaving the drain and overﬂow assembly attached to the drain pipe.

Remove the temporary 2x4 support from the installation area.

Cement and assemble the drain and overﬂow components. Connect the drain to the drain pipe.

Apply slow-drying silicone adhesive to the bottom of the shroud.

Carefully position the shroud over the drain, aligning the hole with the traced mark on the ﬂoor.

Apply sealant to the

bottom before positioning.

Attach to the

drain pipe.

Dry fit the

drain assembly.

Temporary

2x4 Support

Kohler Co. 7 1237792-2-E

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

No comments

Kohler K-5702-GW-0 Installation Guide Page 7