Kohler K-1189-C1-96 Installation Guide download pdf (Page 9)

5. Position the Unit

IMPORTANT! Risk of product damage. Do not lift or support the overﬂowing bath by the pump or

piping.

NOTE: Do not use adhesive or a cement or mortar bed to secure this product to the subﬂoor.

With help, carefully lift the overﬂowing bath into place. Using metal plates under the adjustable feet

is recommended and will make leveling the bath easier.

NOTE: If you do not have a 6’ (1.8 m) level, go to the next section.

Level by turning the adjustable feet up or down with the wrench (7/8″) attached to the harness near

the pump. Make sure all four adjustable feet rest directly on the subﬂoor, and make sure the bathing

well rim is level within 1/8″ (3 mm) in all directions.

After the overﬂowing bath is level, adjust the leveling foot located underneath the pump. Turn the

foot until it rests directly on the subﬂoor. Use an accurate 4’ (1.2 m) level, if available. Taking the

time to carefully level the overﬂowing bath now minimizes the need to make leveling adjustments

later in the installation.

Cut and discard the banding straps from the pump.

Make sure the rubber isolation feet are in place.

Insert the drain tailpiece into the trap.

Adjustable

Foot

Wrench

Metal Plate

Pump Banding

Straps

Kohler Co. 9 1019731-2-D

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 63 64

No comments

Kohler K-1189-C1-96 Installation Guide Page 9