Kohler K-1189-C1-96 Installation Guide download pdf (Page 16)

15. Using Your Bath

Fill the Overﬂowing Bath

NOTE: Please read these steps carefully before you operate your bath.

Make sure the metal suction screen is clean, and is correctly in place over the plastic suction cover.

NOTE: The water temperature in the bath should not exceed 104°F (40°C) or the heater will not operate.

IMPORTANT! Like any other bath, prevent ﬂooding the area around the unit by entering the ﬁlled

bathing well slowly. This will allow the system to properly drain excess water.

Fill the unit with water so the bathing well overﬂows into the overﬂow channel to the drain. The

channel sensors should be completely covered with water.

The green light in the pump control switch will start to blink automatically within 1/2 minute after

the sensors are submerged to let you know the unit is ready to start.

Operating Sequence

Press the pump control switch to start the pump/motor and begin operation.

As the pump/motor turns on and water begins to circulate, the light on the pump control switch

will change to solid green, and will stay on as long as the overﬂowing bath is running.

Verify that the indicator light for the heater is on when the overﬂowing bath is in operation. This

indicator light is located on the underside of the heater box, and is near the subﬂoor at the pump

end of overﬂowing bath. If the light is not on when the overﬂowing bath is running, try and reset

the GFCI/ELCB.

Press the pump control switch again to turn off the overﬂowing bath. The green light in the pump

control switch will then start to blink automatically for approximately 1/2 minute until the

overﬂowing bath is drained below the overﬂow channel sensors or restarted.

NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.

Press the pump control switch again to start the pump/motor and begin operation.

Press the ″On/Off″ control switch to start the pump/motor and begin operation.

An orange light in the ″On/Off″ control switch will temporarily turn on to indicate the start of the

operating mode.

Overflow Channel

Drain

Overflow

Channel

Sensors

Water

Bathing

Well Rim

Control Pad

1019731-2-D 16 Kohler Co.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

Kohler K-1189-C1-96 Installation Guide Page 16